Chitongda YL-007M2 Manuel d'utilisateur télécharger pdf (Page 10)

The remote controller can’t control the main unit after it’s deleted.

In setup state, use keypad to input [21], then input the remote controller

number [1-8], and then press [#] to confirm. The main unit emits a long

beep and the [Signal] indicator flickers once. You will hear a voice

prompt “delete completed”.

Operating method: [21]  [A]  [#]

A indicates: 1~8 remote controllers number.

7. Coding of Defense Zone

Wireless detectors have to be coded to the main unit in order to trigger it

alarm. The wireless PIR and door sensor in the standard package have

been coded.

In setup state, use keypad to input [23], input the defense zone number

you want to code [01~99], and then input [#] to confirm. The main unit

emits a long beep and the corresponding defense zone is displayed on the

screen. You will hear a voice prompt “detector coding”. Then trigger a

wireless detector to emit a wireless signal; after receiving the signal, the

main unit makes a long beep, and you will hear “coding completed”, the

[ ] indicator goes out at the same time.

Operating method: [23]  [XX]  [#]

XX indicates: 01 ~99 defense zones number

LCD display:

8. Delete Defense Zone

The wireless detector can’t control the main unit after it’s deleted.

In setup state, use keypad to input [24], then input the defense zone

number you want to delete [01~99], and then input [#] to confirm. The

main unit emits a long beep and the defense zone indicator flickers once.

You will hear a voice prompt “delete completed”.

Operating method: [24]  [XX]  [#]

XX indicates: 01 ~99 defense zones number

9. Change Password

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 33 34

Pas de commentaire

Chitongda YL-007M2 Manuel d'utilisateur Page 10